BENDIX M-21-M-22 ANTILOCK MOD ASSY Spezifikationen PDF herunterladen (Seite 94)

9 Appendix II

Meritor WABCO Maintenance Manual MM-0112 (Revised 05-13)

The SAS calibration is now completed. The ATC lamp will blink

continuously to inform driver ECU is in learning mode.

If SAS calibration fails; recheck the SAS connection and verify SAS

mounting. Cycle ignition and retry SAS calibration again.

ESC Initialization

Access the ESC EOL menu as in SAS calibration but instead in the

message box that appears, click the “ESC Initialization” button.

Figure 9.12.

Figure 9.12

Check the message box that appears. Press the space bar or click

the “Continue” button when ready to proceed. Figure 9.13. The ATC

lamp will start blinking to inform driver ECU is in learning mode.

Figure 9.13

Tip: Carefully follow the instructions that appear in the

message box. Figure 9.13. Once the ESC initialization is

started, the messages will automatically change as the

requirements are met. DO NOT click the “continue” button

again as this may cause the process to fail. The ESC

Initialization procedure requires the vehicle to be driven.

NOTE: If SAS calibration was completed before ESC initialization, the

ATC lamp will be continuously blinking before ESC initialization

begins. Figure 9.14.

Figure 9.14

The straight driving adjustment can be done in segments as the ECU

will accumulate the information until the 800 feet is reached.

Cornering and stopping is allowed as long as calibration is done

within the same ignition cycle.

When the Straight Driving Adjustment is completed after ECU

accumulated 800 feet of straight driving, the ATC lamp will stop

blinking and will remain ON.

The screen will automatically change to the next portion of the

procedure. Figure 9.15.

Figure 9.12

Figure 9.13

4010680a

4010681a

Figure 9.14

4010682a

1 2 ... 89 90 91 92 93 94 95 96 97 98

Keine Kommentare

BENDIX M-21-M-22 ANTILOCK MOD ASSY Spezifikationen Seite 94