
3 Diagnostics, Troubleshooting and Testing
16
Meritor WABCO Maintenance Manual MM-0112 (Revised 05-13)
Diagnostics: The process of using blink codes to determine ABS
faults.
Fault: An ABS malfunction detected and stored in memory by the
Meritor WABCO ECU. System faults may be Active or Stored.
Active Fault: A condition that currently exists in the ABS; for
example: A sensor circuit malfunctions on the left front steering
axle. An active fault must be repaired before it can be cleared from
memory — and before you can display additional blink code faults.
Stored Fault: There are two types of stored faults:
A. A repaired active fault that has not been cleared from the
ECU.
B. A fault that occurred but no longer exists. For example, a
loose wire that makes intermittent contact. Because stored
faults are not currently active, they do not have to be repaired
before they can be cleared from memory.
Meritor WABCO recommends you keep a record of these faults for
future reference.
System Configuration Code: One-digit code displayed during the
clear mode. Blink codes for common ABS configurations are shown
in Figure 3.10.
Figure 3.10
Clear Mode
To erase faults from the ECU, you must be in the clear mode. To
enter the clear mode, press and hold the blink code switch for at
least three seconds, then release.
If the system displays eight quick flashes followed by a system
configuration code, the clear was successful. Stored ABS faults
have been cleared from memory.
If you do not receive eight flashes, there are still active faults that
must be repaired before they can be cleared.
NOTE: The clear mode is also used to disable the ATC function.
Figure 3.10
4S/4M
6S/6M - 6x2
6S/4M
1002020c
6S/6M - 6x4
NUMBER OF
FLASHES
ABS
CONFIGURATION
Kommentare zu diesen Handbüchern