BENDIX BW2594 Bedienungsanleitung PDF herunterladen (Seite 16)

Bendix

BA-921

Compressor Installation and Application Review

Section IV Air System Components (cont’d)

Air Dryer

Air Dryer part number and/or vendor: ____________________________

Maximum allowable temperature to the dryer: 160

(Bendix Air Dryers Requirement)

Minimum allowable temperature to the dryer: 45

F above lowest ambient

(Bendix Air Dryer Requirement)

Recommended Test Procedure:

Install a temperature probe at the air dryer inlet fitting. Operate the vehicle such

that the engine is at operating temperature. Drain an air tank such that the

compressor runs continuously, but the pressure remains about 10 psi below the

governor cut-out pressure. Note the dryer air inlet temperature after the

compressor has run for 90 seconds with the engine running at rated speed. Also

note the ambient temperature. To obtain the maximum air inlet temperature, add

the difference between the recorded inlet temperature and the noted ambient

temperature to the maximum expected ambient temperature. Likewise, add the

temperature difference to the minimum expected ambient temperature.

Measured inlet temperature to the dryer: __________________________

Ambient temperature at time of measurement: _____________________

What is the maximum expected ambient temperature? ______________

What is the minimum expected ambient temperature? _______________

What is the maximum expected dryer inlet temperature? ______________

What is the minimum expected dryer inlet temperature? ______________

Page 16 of 18

1 2 ... 11 12 13 14 15 16 17 18

Keine Kommentare

BENDIX BW2594 Bedienungsanleitung Seite 16