BENDIX BW2000 Bedienungsanleitung PDF herunterladen (Seite 33)

IMPORTANT!

Do not use Grease containing molyb-

denum disulphate. Use only Bendix

Actuators recommended

by the Vehicle Manufacturer.

12 Actuation cylinder replacement

(for “Axial- and Radial Disc Brake”)

Before fitting the new Brake Actuator, the sealing

surface of the Caliper (see arrow) must be cleaned, and

the Spherical Cup (19) in the Lever must be greased

with white Grease RENOLIT HLT2 (Order no II14525).

The surface area of the flange must be clean.

Attach Actuator with new Nuts

(self-locking EN ISO 7042) and torque tighten

to 133

+22

ft. lbs. (180

+30

Nm).

Connect the air hose and check for leakage.

Make sure that the hose is not twisted and that chafing

is not possible.

IMPORTANT!

Test any air hoses or fittings removed

during maintenance work, using a soap

18/2

VF 00127/10

M+P-KN-034-Äi01

12.1 Brake Chamber removal

Disconnect the air line from the Brake Chamber (18/2)

Unscrew the Brake Chamber Mounting Nuts (do not

re-use them).

Remove the Brake Chamber

12.2 Brake Chamber fitting

IMPORTANT:

New Brake Chambers (18/2) have drain plugs instal-

led. Remove the bottom plug (see arrows). All other drain

holes should be plugged.

Road test vehicle before returning to service.

solution to check for leakage. A 1 inch

bubble in 1 minute is acceptable, otherwise

repair/replace components as necessary.

1 2 ... 28 29 30 31 32 33 34 35 36

Keine Kommentare

BENDIX BW2000 Bedienungsanleitung Seite 33