BENDIX BW1726 Bedienungsanleitung PDF herunterladen (Seite 23)

SECTION VI B - TESTING THE MODULATOR

GO TO MODULATOR, INSPECT WIRING CONNECTOR.

DISCONNECT CONNECTOR AND TEST RESISTANCE

BETWEEN PINS ON MODULATOR. RESISTANCE

VALUES FOR BENDIX

M-22

™

MODULATOR.

HOLD TO COMMON: READ 3.5 TO 5 OHMS

EXHAUST TO COMMON: READ 3.5 TO 5 OHMS

EXHAUST TO HOLD: READ 7 TO 10 OHMS

TEST EACH PIN TO VEHICLE GROUND AND NOTE NO

CONTINUITY.

REPLACE THE MODULATOR.

YES

REPEAT THE “INITIAL

START-UP PROCEDURE”

REPAIR OR REPLACE MODU-

LATOR WIRE HARNESS.

GO TO SECTION IV “INSPECTION FOR

ILLUMINATED LEDs” AND RETEST.

YES

EXHAUST COMMON HOLD

CONNECTOR ON M-22

™

MODULATOR.

RECONNECT CONNECTOR TO MODULATOR.

TURN IGNITION ON AND PASS MAGNET OVER

RESET ON EC-16

™

CONTROLLER. NOTE

REACTION OF RED LEDs.

RESISTANCE READINGS

CORRECT?

START HERE FROM

SECTION VI A

ARE ANY RED LEDs

ILLUMINATED?

SAME RED LEDs

ILLUMINATED?

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

BENDIX BW1726 Bedienungsanleitung Seite 23