BENDIX BW1663 Bedienungsanleitung PDF herunterladen (Seite 11)

LED o FRONT Red LED

LED o MID Red LED (SEE NOTE BELOW)

LED o REAR Red LED

LED o RIGHT Red LED

LED o LEFT Red LED

LED o MOD Red LED

LED o SENS Red LED

LED o ECU Red LED

LED o VOLT Green LED

III RESET No LED

NOTE: The MID LED shown in the chart above is not used

in the diagnostic process for the EC-15

™

controller

however it will light when a magnet is placed on the

RESET switch in the diagnostic window.

“FRONT” LED

This Red LED illuminates and latches ON in order to indicate

the location of a problem component or its wiring. It will

light in conjunction with either the RIGHT or LEFT LED and

the MOD or SENS LED.

“MID” LED

This Red LED is not used in troubleshooting the EC-15

™

controller and should light only when a magnet is held on

the RESET switch.

“REAR” LED

This Red LED illuminates and latches ON in order to indicate

the location of a problem component or its wiring. It will light

in conjunction with either the RIGHT or LEFT LED and the

MOD or SENS LED.

“RIGHT” LED

This Red LED illuminates and latches ON in order to indicate

the location of a problem component or its wiring. It will light

in conjunction with either the FRONT or REAR LED and the

MOD or SENS LED.

“LEFT” LED

This Red LED illuminates and latches ON in order to indicate

the location of a problem component or its wiring. It will light

in conjunction with either the FRONT or REAR LED and the

MOD or SENS LED.

“MOD” LED

This Red LED illuminates and latches ON to indicate a

permanent or intermittent open or short circuit in the

solenoids of one of the four modulators or the wiring

connecting it to the system.

“SENS” LED

This Red LED illuminates and latches ON to indicate

permanent or intermittent failure. The failures indicated are;

open or shorted wheel speed sensor, open or shorted wheel

speed sensor wiring, wheel speed signal not present or

does not conform to design criteria.

“ECU” LED

This Red LED, when illuminated, indicates that the controller

itself has failed. It is latched ON for all EC-15

™

controller

failures except low voltage. For voltages less than 9VDC,

the LED illuminates to indicate the controller is inoperative,

however when the voltage again exceeds 9VDC the LED will

go OUT by itself.

“VOLT” LED

This Green LED illuminates and remains ON during vehicle

operation to indicate that vehicle power is reaching the

controller. If vehicle power is out of range for proper

operation (below 11 vdc or above 17 vdc) this LED will flash

until power is brought into range.

“RESET”

Beneath the RESET area of the window display is a

magnetically sensitive switch that is used to reset the

diagnostic system. The device will respond to a magnet

which has strength sufficient to lift a three (3) ounce weight.

Holding a magnet against the RESET will cause all LEDs to

light during the time the magnet is against it.

FRONT

MID

REAR

RIGHT

LEFT

MOD

SENS

ECU

VOLT

RESET

EC-15

™

CONTROLLER

DIAGNOSTIC WINDOW

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

BENDIX BW1663 Bedienungsanleitung Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Modulator BENDIX BW1663