BENDIX GEN 4 GEN 5 ABS Betriebsanweisung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
11
Control buttons for customize.
OK means to accept changes.
Cancel means do not accept changes.
Up moves highlighted test up in the list.
Down moves highlighted test down in the list.
If there are any active DTCs on the ECU the installation
will not run and the technician will be noti ed by a
message. Active DTCs need to be corrected and
cleared before the installation test can be performed.
Figure 30
ECU Information
ECU information test is a mandatory test, it must always
be run. It provides the technician with information
about how the ECU is con gured.
Figure 31
Axle Load Test
The axle load test is mandatory for the TABS-6 ADV,
but not for the TABS-6 MV. The axle load test displays
the weight on the rear axle in pounds.
Figure 32
Installation Angle Test
The installation angle test displays the vertical angle of
the mounted ECU. The vertical angle must be within
±5 degrees of vertical. NOTE: Installation Angle Test
will be available if the ECU supports TRSP.
Figure 33
Battery Voltage Test
The battery voltage test checks the battery voltage
received at the ECU with the modulators de-energized,
energized and de-energized. The TABS-6 ADV / MV
and MC voltage range is 8.0 VDC to 32.0 VDC.
Figure 34
ABS Indicator Lamp Test
The ABS indicator lamp test will illuminate and
extinguish the ABS indicator lamp while the technician
veri es the correct operation of the ABS indicator lamp.
Figure 35
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare