BENDIX SD-13-4788 Bedienungsanleitung PDF herunterladen (Seite 18)

SECTION I - ANTILOCK DASH LAMP TESTING

YES

CHECK WIRING HARNESS AND RELAY FOR

SHORTS TO GROUND. RECONNECT AND

CHECK/REPLACE THE FOLLOWING:

1. DASH LIGHT BULB

2. FUSE

3. RELAY POWER WIRE

4. RELAY

AFTER REPLACING EACH COMPONENT

TEST THE DASH LAMP.

REPLACE THE

EC-17

™

CONTROLLER

START HERE

TO DASH LAMP

RELAY

GROUND

REPAIR OR REPLACE

WIRE HARNESS

REPLACE RELAY &

RETEST FOR BATTERY

VOLTAGE

SECOND TIME TO

THIS POINT?

IS VOLTAGE CORRECT?

REPEAT THE “INITIAL

START-UP PROCEDURE”

WITH IGNITION ON, MEASURE VOLTAGE BETWEEN

PINS E3 & A1, A2, A3. VOLTAGE SHOULD BE SAME

AS BATTERY VOLTAGE

YES

DISCONNECT 30 PIN CONNECTOR FROM

EC-17

™

CONTROLLER AND OBSERVE THE

ANTILOCK DASH LAMP.

ANTILOCK DASH LAMP

ILLUMINATED?

A1, A2, A3

GROUND

DASH LAMP

RELAY

VEHICLE POWER

(IGNITION)

TO DASH LAMP

RELAY

DASH LAMP

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

SD-13-4788 1
PHYSICAL 3
MOUNTING 3
CONTROLLER INFORMATIONAL 3
INPUTS AND COMMAND OUTPUTS 3
FIGURE 5 - EC-17 4
FIGURE 6 - M-30 5
, AND M-32QR 5
MODULATORS 5
OPERATION - ANTILOCK (ABS) 6
AUTO CALIBRATION 8
SINGLE FAILURE 8
MULTIPLE FAILURES 8
ANTILOCK AND TRACTION WIRING 9
PREVENTIVE MAINTENANCE 9
INJURY OR DEATH: 9
IMPORTANT: 11
LAMP CONFIGURATION TABLE 12
CONTROLLER CONFIGURATION 13
CONTROLLER SELF CONFIGURING 14
TROUBLESHOOTING 15
DIAGNOSTIC DISPLAY 16
QUICK REFERENCE 16
INITIAL START-UP PROCEDURE 17
GREEN VLT LED 19
RED LEDs 19
CONTROLLER 22

Kommentare zu diesen Handbüchern

Keine Kommentare

BENDIX SD-13-4788 Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor BENDIX SD-13-4788